Tutorials
Appraiser · walkthrough
Turn a field sketch into a drawing you can verify
Check geometry, labels and calculated area before using a draft drawing.
Updated 3 steps
On this page
Before you start
- A legible field sketch or plan you are authorized to use
- Your measured dimensions
The complete walkthrough
Step 1: Provide a readable sketch
Include the full perimeter, dimensions, level labels and attached areas. Keep essential annotations legible.
Check
The source distinguishes living area, garage, porches and other areas.Step 2: Compare the draft
Compare each exterior segment and attached block with the original. Check room labels, levels, units and openings where relevant.
Check
No missing edge or invented dimension is accepted because the drawing looks plausible.Step 3: Correct and recalculate
Correct the geometry and classification using your measurements. Review totals after edits and inspect the exported drawing.
Check
The exported plan reflects the corrected geometry. Confirm area treatment using the requirements applicable to the assignment.
Before you move on
- Perimeter verified
- Attached areas classified
- Levels and units checked
- Export compared with source